Click on the image to check the artwork
By certification 
ZRWG02B Bull leather heel grip Make sure the heel area of your shoes is free of dirt and oil. The adhesive backing is very strong. Therefore, before you attach Stop to your shoe we suggest you test for correct placement in your particular shoe or boot. To test for correct placement, use a loop of scotch tape or remove only a very small section of Stops adhesive backing. Place Stop in the heel of your shoe and see if it is exactly where you need it to be. Shoes fit differently, so repeat these steps for your other shoe. Walk around and try different positions on the heel. Once you are satisfied that the grips is are where they will do the most good, use a pencil or pen and mark the location with a few dots at several points on Stops sides, top, and bottom. Peel off the adhesive backing and place Stop within your outline. If your shoes are tight, or if you rub the heel area taking them on and off, please use a shoehorn to keep the adhesive seal intact.
ZRWG023 PU/bull leather heel grip
Reduce the friction between foot and shoes heel.
Abreast place should be kept clean and dry. After removing backing paper, pasted it to the heel and and press heel grip onto upper part of heel.
Padded grips keep your heels from slipping out of your shoes.
Protect against blisters or cuts behind the heels. Prevent the foot from sliding out of or around in the shoe.
leather heel grips-unisex.
ZRWG03 Blister shoe pads
Easy peel off silicone gel can be used in any shoes or sandals-Stays on so you always have cushion where you need it. Can also be used on bottom of socks for anti-slip protection
Wear all day. Rests comfortably on any part of the foot to help eliminate pressure and friction
Helps relieve pain from bunions, blisters, pressure spots, and heel pain
Extra sticky and easy to apply and remove. Can be worn on skin or on inside of shoes and sandals
